We can manufacture and supply mill stands for rolling Wire rods / TMT / Light Section / Medium Section & Heavy Sections steel and of ferrous and non ferrous metals. These cost- effective conventional stands are available in both fibre bearing as well as anti-friction bearing. They can be opened or closed type.

We also manufacture advanced pre-stressed mill stands that are known for their consistency in maintaining stock sizes. These stands provide significant advantage of both closed top, of rigidity and open top, of easiness in roll changing. Pre - stressed mill stand can be availed in 3 High as well as 2 High configurations based upon the requirement of the clients. The unique cassette design of the stand reduces the roll changeover to almost 10 to 15 minutes.

We offer best solutions for mill stands to our clients with due regards to production, steel grades, easiness of maintenance and quality requirements.

Features

• Heavy duty and sturdy design which is suitable to bear overloads
• Roll drafting arrangement
• Axial adjustments
• Hydraulic stand clamping
• Constant pass line
• Can be placed in both horizontal and vertical configurations

Crop & Cobble shears are start / stop type and are driven either with flywheel mounted pneumatic clutch/ brake or direct DC motor driven. These machines are used in hot rolling to front end, tail end and as well as to segment cutting in case of eventualities. The system provides very close cut length. Our crop cable can be configured with PLC for precise control over the process.

Our range of cooling bed dividing shear uses thermo mechanical treatment process for reinforcement bars. These Shears are generally installed after quenching line & before entry to cooling bed. The dividing shear cools straight bar lengths to a temperature suitable for subsequent processing (around 3500C min.), to align front ends of bars for better yield, to form layers for feeding.

Rotatory are extensively used to crop front, tail and as well as to scrap the pre quenched bars during emergency. The continuous rotating sheer allow for cutting the largest of sheets. Our rotatory shear has been specifically designed to trim Hot Rolled Bars considerably at lower speed.

Our advanced range of hot saw is an ideal way to help maximize the efficiency of the extrusion system. These saws are designed to cut every billet to the precise size as well as to trim front & Rear End. They are capable of cutting section size ranging from 160 to 600mm (Beam, Channel, Angle) and as well as square, racks of 40 to 250mm. We offer hot saws in two different models including Pendulum Swinging and horizontal shift type.